GPS 3-145
March 2009 Chapter 3 - MTP850 Ex/MTP810 Ex Product Information Manual 6866588D21-D
30.1.5 Beep for GPS Coverage
If the parameter is enabled, the GPS Coverage audio indications are enabled in the terminal.
If the parameter is disabled, the GPS Coverage audio indications are disabled in the terminal.
Turn the check box on (Enable) or off (Disable) by clicking in the check box.
30.1.6 Icon for GPS Coverage
If the parameter is enabled, the GPS Coverage visual indications are enabled in the terminal.
If the parameter is disabled, the GPS Coverage visual indications are disabled in the terminal.
Turn the check box on (Enable) or off (Disable) by clicking in the check box.
30.1.7 GPS Authorised ISSI Base
This ISSI is the first in the range of ISSIs acceptable as authorized. (When receiving location service
requests, the terminal checks the calling party ISSI of downlink location service requests.)
The range is any valid ISSI, or the NO ISSI reserved value. (NO_ISSI is a reserved value outside
the range of possible ISSIs, and only used to indicate that no ISSI has been assigned to the field in
question.)
Type in the first valid ISSI.
30.1.8 GPS Authorised ISSI Range
This parameter defines the range (or offset) of authorised ISSIs - start from “GPS Authorized ISSI
Base”.
Type in the range/offset for the last valid ISSI.
30.1.9 GPS Coverage Poll Period
This number is the period (in seconds) in which the GPS Coverage is checked when out of GPS
coverage and the GPS icon is updated accordingly.
Type in (in seconds) how often the GPS Coverage should be checked.
30.1.10 Preferred Position Calculation Mode if DCK is Off
When DCK (Digital Car Kit) is off, the radio has only its own battery as power source. This means
normally all hardware works in power save mode if possible. But, it is also possible to get more
exact position data, even when DCK is off.
This leads to high power consuming of the GPS related hardware, because it then works in the
same mode as it would be in "DCK on" status.
The battery will then be empty earlier when this mode is active.
This parameter allows user to configure the terminal to deliver more (and more exact) position data
even when DCK is off.
Therefore, the terminal works in a mode that is normally not used when DCK is off.
30.1.11 MMI Accuracy Menu
This field is used to store information on whether the terminal’s user can see and use the GPS
Accuracy menu or if it is hidden from him.
If this field is set to Enabled (field checked off), the terminal will show the GPS Accuracy menu to the
user. The user can choose between two GPS tracking modes outside of a digital car kit (DCK) with
To Next Page
Loading...
