Motorola MTP850 Ex - 30.4.1 Periodic; 30.4.2 Moved; 30.4.3 Powered up

GPS 3-149
March 2009 Chapter 3 - MTP850 Ex/MTP810 Ex Product Information Manual 6866588D21-D
Max Data Age
Indicates the default maximum age allowed for data in Location Report message for triggered
reports.
Type in the value. This value will be mapped to an actual value as shown in the second column of
the mapping table.
Max Response Time
Specifies the maximum duration the GPS system has to acquire location data.
Type in the required value.
Max Report Distance
Defines the distance interval at which distance-based Location Reports are sent when not inserted
in a Digital Car Kit.
Type in the required value.
Distance Check Interval
Maximum interval (in seconds) at which MS checks its position for position-based Location Reports
when not inserted in a Digital Car Kit.
Type in the required value.
Low Battery Level
Indicates the percentage of battery level triggering the "Low Battery" condition.
Type in the required value.
30.4.1 Periodic
This is a periodic Location Reports sent by the terminal outside Emergency Mode.
While the terminal is not in Emergency Mode, and depending on the "Periodic" Trigger Enable
settings, it will acquire its position and send periodic Location Reports at intervals defined by the
GPS Idle Report Period (unless reports of that nature are inhibited, in which case it will do nothing).
Normal GPS periodic location reports are inhibited when the radio is in Emergency Mode. If GPS
periodic location reports are required during Emergency Mode, then it is necessary to enable the
Emergency Periodic reports.
30.4.2 Moved
At defined time intervals, the terminal checks its location against the last reported position, and
sends a Location Report whenever the check shows the position has changed by the specified
distance.
Note: A distance based location report is only sent if the distance between the measurement and
the last reported position is higher than the distance threshold. The real moved distance could
be higher (for example: coming back or going around the first point); also the change will not
be reported when its time elapsed is less than the preset time period.
30.4.3 Powered up
When the terminal is powered up, and subject to the "Powered up" Trigger Enable settings, it will
acquire its location and send a Location Report after performing the power up sequence.