Ordering the Software Enablement Kits 1- 19
March 2009 Chapter 1 - MTP850 Ex/MTP810 Ex Product Information Manual 6866588D21-D
6 Ordering the Software Enablement Kits
Each kit number ordered will provide one dongle for the customer with a certain number of counters
set according to the number of software option ordered.
This kit number is applicable to both new orders or existing fielded terminals which required
software enablement.
These kits are applicable to MTP850 Ex/MTP810 Ex terminals.
Software Selling - Tools and Mechanisms
For MR8.6 the chosen approach is a dongle with counters for each one of the features. The features
are enabled at the same time the customer programs the radio. This will happen in one operation.
• A dongle is connected to the PC which is used to configure the TETRA terminal.
• The dongle has a counter for each of the features.
• The dongle counters are “charged” as per what the customer has ordered/purchased (for
example WAP in 100 TETRA terminals).
• Every time a feature is enabled in a terminal the dongle counter is decreased for the feature in
question.
Note: For activating the appropriate features please refer to chapter “Customer Programming
Software”, paragraph “Enable Features” or refer to the CPS Start-Up
Manual (6802974C10_) on the CPS CD for more information on how to implement the
supplied software.
To Next Page
Loading...
