116
Setting the Display’s Working Language
From the main menu, select Setup
> Language
.
The display shows the current language
used. You can customize your MTP850 Ex/
MTP810 Ex to operate in English, German,
French, Spanish, Dutch, or in a language
defined by your Service Provider. The default setting from
factory is English.
Scroll to the desired language and press Select
.
The display
shows the selected language for a few seconds.
Setting Up the Data Function
You can connect the MTP850 Ex/MTP810 Ex to an external
device (such as a laptop or desktop PC). The MTP850 Ex/
MTP810 Ex will then be capable of transmitting and receiving
data from the external device. To connect the MTP850 Ex/
MTP810 Ex accessory connector to the external device, use
cable FKN4897. The external device must run an application
complying with the TETRA standards.
From the main menu, select Setup > Data
Setup
.
The display shows the current setting:
• Voice Only
– The MTP850 Ex/MTP810 Ex
will receive and transmit voice calls only.
• Data Only
– The MTP850 Ex/MTP810 Ex
acts as a modem. The MTP850 Ex/MTP810 Ex will reject
incoming and outgoing voice calls (except for Emergency
Calls), status and text messages.
• Voice & Data
– The MTP850 Ex/MTP810 Ex acts as a
modem but voice calls will have priority over data calls and
will interrupt them.
Scroll to the desired setting and press Select
.
Language
Deutsch
Français
English
Select Back
Español
Nederlands
Data Setup
Data Only
Voice & Data
Voice Only
Select Back
To Next Page
Loading...
