127
Set Scanning to On
Scanning is Off. Select
On.
A message may
indicate that all scan lists are empty. Select
Scan Lists to fill the scan list(s).
The display shows the following state:
Then, the display shows (for example) the
Scanning Scan List 1 message. The
terminal will then try to attach to this list.
Set Scanning to Off
Scanning is on. Select Off. The display
shows the following state:
Then, the display shows the Scanning is Off
message.
Selecting a List with Scanning On
1.
Select SelectList.
2.
To select a list other than the highlighted
one, scroll and press Select
.
The display
shows (for example) the Scanning Scan
List 1 message. The terminal will then try to
attach to this list.
Selecting a List with Scanning Off
1.
Select SelectList.
2.
To select a list other than the highlighted one, scroll and
press Select
.
The display shows (for example) the Scan
List 1 Selected
message.
The Network List
Your terminal can scan (and attach) to a list belonging to
another infrastructure than the Dimetra infrastructure:
• Upon pressing Select, if the Network List is selected, only
this list will attach. If a user list is selected, then both the
Network List and the user list will be attached.
Scanning
SelectList
On
Select Back
Scanning
SelectList
Off
Select Back
Scan Lists
Scan List 1
Network List
Select Back
Scan List 2
Scan List 3
To Next Page
Loading...
