• Home Group – when changing modes the radio enters the DMO Home Group, ignoring possible group
mappings.
6 Select TMO Home Group – configures the TMO Home Group/Home Folder.
7 Select DMO Home Group – configures the DMO Home Group.
Scan
This menu item allows you to activate/deactivate scanning, view the active scan list, and edit the scan lists. This
feature is available only for the TMO Mode. Your radio joins any group call as long as this group is defined in the
scan list and scan is turned on.
Activating Talkgroup Scanning
When and where to use: If you want to monitor any TMO Group Call in the defined talkgroup list.
Procedure:
1 From the home screen, press the MENU key.
2 Select More . . . → Group Setup → Scan → Scanning.
3 Select Select List and then a list name.
Your radio displays list name Selected.
4 Select Scanning → On.
Your radio is scanning on the predefined scan list.
Setting Talkgroups in the Active Scan List
When and where to use: If you want to edit talkgroups in the active scan list.
Procedure:
1 From the home screen, press the MENU key.
2 Select More . . . → Group Setup → Scan → Active List.
Note: If Scanning is Off is displayed, go to More . . . → Group Setup → Scan → Scanning → On to
enable scanning.
3 Select View and highlight the required talkgroup.
4 Press MENU.
5 Select one of the following:
• Delete — Erases this group from the active scan list.
• Priority and select new priority to Low, Medium or High.
Setting Scan Lists
When and where to use: If you want to set up any scan list.
Procedure:
1 From the home screen, press the MENU key.
2 Select More . . . → Group Setup → Scan → Scan Lists.
3 Highlight required scan list and press MENU to see additional settings:
• Rename — Enters new name for that scan list.
• Capacity — Displays the number of assigned and unassigned talkgroups for the scan list.
• Clear — Deletes all the talkgroup assigned to that scan list.
92 | Main Menu
Send Feedback | |
To Next Page
Loading...
