MAINTENANCE MTP850 TETRA Handportable Terminal / Basic Service Manual 6 - 21
To install the Display
1. Verify that no damage exists on the LCD glass. Install the protective film back
in place.
2. Locate the display above the chassis and slide left side of LCD under chassis
tab and onto left locating pin and ease into place. Verify that the display is
inserted into the 2 location pins.
3. Carefully install the display holder. Verify that the holder is securely snapped
into the slot.
4. Remove the protective film from the LCD glass.
5. Install the Keypad Board and Main Board. Refer to “Removing and Installing
the Keypad Board and Main Board” on page 6-19.
Figure 16 Display Removal and Installation 1
Figure 17 Display Removal and Installation 2
SEE DETAIL A
DETAIL A
To Next Page
Loading...
