MAINTENANCE MTP850 TETRA Handportable Terminal / Basic Service Manual 6 - 29
To install the UC Flex Assembly
1. Guide and press the flex through the front housing slot.
2. Peel off the flex’s adhesive liner on the inside of the front housing, and apply
pressure to bond it to the front housing using the rib as a guide.
3. Peel off the flex’s adhesive liner on the outside of the front housing, and apply
pressure to bond it to the front housing using the pin as a guide.
Figure 21 UC Flex Assembly Removal and Installation
Assembly guiding features
To Next Page
Loading...
