• Ambience Listening Mode.
• Transmit Inhibit Mode (TXI).
• Emergency Mode.
• Silent Emergency Mode.
• Covert Mode.
Send firmware version and TEI
The radio sends back an SDS message with its firmware version and TEI.
NOTICE: If the sending Individual Short Subscriber Identity (ISSI) is not on the Allowed ISSIs
list, the receiving radio ignores the task.
4.9.8.1
Setting Remote Control
This procedure describes how to toggle remote control.
Procedure:
1 From the home screen, press the Menu key.
2 Select Security → Remote Control.
3 Select On to enable, or Off to disable remote control.
4.10
Setup
This sub-menu allows you to change your radio configuration.
4.10.1
Ring Style
This sub-menu allows you to set the incoming call ring style.
4.10.1.1
Setting Ring Style
Procedure:
1 From the home screen, press the Menu key.
2 Select Setup → Ring Style.
3
Select one of the following:
•
Duplex — to set the new ring style to all duplex calls.
•
Simplex — to set the new ring style to all simplex calls.
NOTICE:
Upon entry into this sub-menu, the display shows the current ring style used.
4 Scroll to the desired style and press Select.
NOTICE:
New ring style is played immediately for a few seconds. If necessary, adjust the
volume level.
MN002033A01–AC (en-US)
Chapter 4: Main Menu
100 Send Feedback
To Next Page
Loading...
