4.18.3
Viewing Testpage
Procedure:
1 From the home screen, press the Menu key.
2 Select Location → Testpage.
3 Select one of the following:
• Position – displays detailed information on radio’s current position: time, N (latitude), E
(longitude), H (height), Sats Used (a number of tracked satellites), B (bearing), HS
(horizontal speed), LC (level of confidence).
• Power – displays detailed information on a particular satellite: PRN code, Status, Mode, C/N
(carrier-to-noise ratio).
• Version – displays detailed information on software version: SW (software version), HW
(hardware version), ASIC (application-specific integrated circuit), RC (release code).
4.18.4
Changing GNSS Accuracy
Procedure:
1 From the home screen, press the Menu key.
2 Select More . . . → Location → Accuracy.
3
Select one of the following:
• Medium (default) – Power consumption optimization is combined with less position accuracy.
• High – Better position accuracy is combined with less power consumption optimization.
NOTICE:
If connected to an external charging device, the radio automatically enters the
High mode.
4.18.5
Backlog
This sub-menu allows you to enable/disable, view, and delete backlog reports.
NOTICE:
The location report backlog is only available when Local Information Protocol (LIP) is
enabled.
4.18.5.1
Enabling/Disabling Backlog
Procedure:
1 From the home screen, press the Menu key.
2 Select Location → Backlog → Enablement.
3
Select one of the following:
•
On — Activates location report backlog recording.
•
Off — Deactivates location report backlog recording.
MN002033A01–AC (en-US)
Chapter 4: Main Menu
128 Send Feedback
To Next Page
Loading...
