4.18.5.2
Viewing Backlog Reports
Procedure:
1 From the home screen, press the Menu key.
2 Select Location → Backlog → Reports.
The radio displays the number of backlog reports stored.
4.18.5.3
Deleting All Backlog Reports
Procedure:
1 From the home screen, press the Menu key.
2 Select Location → Backlog → Delete All.
4.19
Packet Data
NOTICE: This feature is a paid feature.
The Packet Data (PD) Service allows you to transfer data in a TETRA system using the Internet
Protocol (IP).
NOTICE:
To transfer data from a standard computer over the air, connect the computer via the data cable
PMKN4129 with your radio. Your service provider has to setup additional applications on your
computer.
To transfer data from a standard computer over the air, connect the computer via the data cable
PMLN5237 with your radio. Your service provider has to setup additional applications on your
computer.
If set up by your service provider it is possible to accelerate the transmission by using the Multi-Slot
Packet Data (MSPD) Service.
4.19.1
Viewing Data Statistics
Procedure:
1 From the home screen, press the Menu key.
2 Select Packet Data.
NOTICE:
Data services are only available in TMO Mode. The data option must be set to
Voice & Data or Data Only.
3
Select one of the following:
•
Sent Data — the number of KBs sent and throughput since current Packet Data activation is
displayed.
•
Received Data — the number of KBs received and throughput since current Packet Data
activation is displayed.
•
Bandwidth — active data session percentage is shown.
MN002033A01–AC (en-US)
Chapter 4: Main Menu
Send Feedback 129
To Next Page
Loading...
