Icon Description
• attempts to connect to a gateway.
Non-Secured Call – Air Encryption Unavailable
Blinking – Indicates that Air Encryption is not available in DMO Mode. The icon ap-
pears after the PTT button is pressed.
Non-formatted SD Card
• Solid – The microSD card is:
- not formatted at all,
- formatted incorrectly, or
- damaged.
• Blinking – The microSD card is being formatted.
USB Connected – Indicates that the radio is connected to the computer via the USB
cable. Visible only in the Mass Storage mode.
Bluetooth Connected – Indicates that Bluetooth is enabled and at least one device is
connected.
Bluetooth Disconnected
• Solid – Indicates that Bluetooth is enabled, but no device is connected.
• Blinking indicates one of the following:
- Bluetooth is enabled and the radio is in the Discoverable Mode.
- Bluetooth is enabled and a connection with a remote device is being estab-
lished.
An outgoing OPP transfer (upload).
An incoming OPP transfer (download).
Remote Control – Indicates that the radio is being remotely controlled and some
commands are being executed in the background. For example, when the radio is
being controlled by special SDS messages or triggered to send a GNSS location re-
port.
Icon is not visible in Extra Zoom Mode.
2.6
Powering On the Radio
Procedure:
Press and hold On button.
Your radio performs a self-check and registration routine.
After successful registration, your radio is in service.
NOTICE:
Your radio powers on without visible and audible notification if Covert Mode is
activated.
MN002033A01–AC (en-US)
Chapter 2: Getting Started
Send Feedback 41
To Next Page
Loading...
