Motorola MTX1550 - Conventional Features; Repeat;Direct

33
English
CONVENTIONAL
FEATURES
CONVENTIONAL FEATURES
This section outlines the conventional features of your
radio. All references to what is shown on the display is
only valid for Model II radios. Throughout this section,
the display below
is used to indicate the radio’s home display.
REPEAT/DIRECT
The repeat/direct feature allows you to bypass the
repeater and talk directly to another portable radio.
This is known as DIRECT operation. The transmit
frequency is the same as the receive frequency.
• In REPEAT operation, you talk through the
repeater, which increases the radio's operating
range. The transmit frequency is not the same
as the receive frequency.
• If the repeat/direct feature is programmed to a
mode, that mode operates on either direct or
repeat operation.
• If the repeat/direct feature is programmed to the
keypad, you can change the repeat/direct setting
by doing the following.
PLANT POLICE
1 Press / until DIR is
displayed.
2 Press l (the softkey below DIR).
3 The current talkaround
state appears on the
display for a few
seconds.
or
4 Then, the display
prompts for the new
state.
5 Press l below the desired talkaround
state: repeat (RPTR) or direct (DIR).
6 The radio returns to the
home display.
DIR
PWR
PROG
REPEATER MODE
DIRECT MODE
DIR
RPTR
PLANT POLICE