SCAN
35
English
SCAN
This section outlines the scan functions of your radio.
All references to what is shown on the display is only
valid for Model II radios. Throughout this section, the
display below
is used to indicate the radio’s home display.
SCAN OPERATION
The scan feature allows you to monitor activity on
different conventional or trunked modes by scanning a
scan list of modes. This list can be programmed with
the Customer Programming Software (CPS) or user
programmable.
Three types of scan operation are available depending
on radio model.
Your radio may support both priority and non-priority
scanning. With priority scanning enabled, a scan list
can have one mode assigned as the first priority mode,
and a second as the second priority mode.
Automatic scanning (autoscan) can be programmed
through the CPS. If autoscan is enabled for a mode,
your radio begins scanning, using the mode’s scan list,
whenever you select that mode. The radio continues
autoscanning until you select a mode that does not
have autoscan enabled.
Turning Scan On or Off with the Keypad
(For Keypad Radios Only)
Trunking
Priority Monitor
Comprises modes that are all from the
same trunked system.
Conventional Comprises conventional-only modes.
Talkgroup
Scan
Comprises conventional modes and
trunked modes from more than one
trunking system. Priority operation is
NOT available in this type of list.
PLANT POLICE
1 Press / until
SCAN is displayed.
2 Press ; (the
softkey below
SCAN).
You will see the
current scan state
momentarily.
or
Then
PHON
SCAN
CALL
SCAN ON
SCAN OFF
ON
OFF
20L01-A_PR_UG_MTX4500.book Page 35 Friday, April 13, 2007 2:47 PM
To Next Page
Loading...
