Motorola MTX1550 - Programming a Scan List (for Keypad Radios Only)

SCAN
37
English
Note: The programming-mode annunciator, K, is
displayed while list view mode is active.
• The scan status annunciator, G, appears,
indicating that a scan list is being viewed.
• The dot of the priority scan annunciator,
H, blinks if the current displayed
member of the scan list is a priority 1
mode, and is solid the current displayed
member of the scan list is a priority 2
mode.
Programming a Scan List (For Keypad
Radios Only)
The program scan list feature allows you to program
the members of the scan list associated with the
currently selected mode.
To program a scan list
Note: The programming-mode annunciator, K,
blinks while program mode is active.
• The scan status annunciator, G, appears,
indicating that a scan list is being viewed.
• The dot of the priority scan annunciator,
H, blinks if the current displayed
member of the scan list is a priority 1
mode, and is solid the current displayed
member of the scan list is a priority 2
mode.
1 Press / until
PROG is displayed.
2 Press l (the
softkey below
PROG).
3 Press l (the
softkey below
SCAN). The display
shows the current
mode selected.
For example
PROG
SCAN
PHON
CALL
FIRE DEPT
4 Use the mode selector knob to select the
required talkgroup zone.
5 Press , or / to select the required
zone. If the scan status annunciator G is
displayed, the mode is part of the scan list.
6 Press the select key to change the scan
mode (See Scan Modes on page 38).
7 After making all the changes, select the
required operating mode.
8 Press the HOME key, or the PTT switch, or
turn the mode selector knob to commit all the
changes made.
20L01-A_PR_UG_MTX4500.book Page 37 Friday, April 13, 2007 2:47 PM