38
English
SCAN
Scan Modes
Note: There can only be ONE Priority 1 member
and ONE Priority 2 member in a scan list.
Thus, if there is already a Priority 1 member
in the scan list, changing another member’s
mode to Priority 1, would automatically
cause the previous member’s mode to be
changed to a Scan Member.
This same behavior is also seen when
programming the Priority 2 member.
Initial Scan Mode
of Member
Number of Times the Select Key is Pressed
1 2 3 4
Priority 2* Priority 1*
Non-Scan
Member
Scan Member Priority 2*
Priority 1*
Non-Scan
Member
Scan Member Priority 2* Priority 1*
Non-Scan
Member
Scan Member Priority 2* Priority 1*
Non-Scan
Member
Scan Member Priority 2* Priority 1*
Non-Scan
Member
Scan Member
* Priority options are only available if enabled.
When programming the scan list, each member can be given one of several scan modes. The following
table lists the scan mode cycle activated by subsequent presses of the select key.
20L01-A_PR_UG_MTX4500.book Page 38 Friday, April 13, 2007 2:47 PM
To Next Page
Loading...
