Motorola MVME2400 Series - Page 107

ENV – Set Environment
http://www.motorola.com/computer/literature 6-5
6
Network PReP-Boot Mode Enable [Y/N] = N?
Negate VMEbus SYSFAIL* Always [Y/N] = N?
SCSI Bus Reset on Debugger Startup [Y/N] = N?
Primary SCSI Bus Negotiations Type [A/S/N] = A?
Primary SCSI Data Bus Width [W/N] = N?
Secondary SCSI identifier = 07?
Select the identifier. (Default = 07.)
Y
Enable PReP-style network booting (same boot image
from a network interface as from a mass storage
device).
N
Do not enable PReP-style network booting. (Default)
Y
Negate the VMEbus SYSFAIL∗ signal during board
initialization.
N
Negate the VMEbus SYSFAIL∗ signal after
successful completion or entrance into the bug
command monitor. (Default)
Y
Local SCSI bus is reset on debugger setup.
N
Local SCSI bus is not reset on debugger setup.
(Default)
A
Asynchronous SCSI bus negotiation. (Default)
S
Synchronous SCSI bus negotiation.
N
None.
W
Wide SCSI (16-bit bus).
N
Narrow SCSI (8-bit bus). (Default)