Motorola MVME2400 Series - Overview of Start-Up Procedures; Table 1-2. Start-Up Overview

1-4 Computer Group Literature Center Web Site
Hardware Preparation and Installation
1
Overview of Start-Up Procedures
The following table lists the things you will need to do before you can use
this board, and tells where to find the information you need to perform
each step. Read this chapter in its entirety along with all Caution and
Warning notes before beginning.
Table 1-2. Start-Up Overview
What you need to do... Refer to...
Unpack the hardware. Unpacking Instructions on page 1-6
Set jumpers on the MVME240x
module.
Hardware Configuration on page 1-6
Prepare the PMCs. PMC Preparation on page 1-11
For additional information on PMCs, refer to the PMC
manuals provided with these cards.
Prepare the PMCspan module(s). PMCspan Preparation on page 1-11
For additional information on PMCspan, refer to the
PMCspan PMC Adapter Carrier Module Installation
and Use manual, listed in Appendix D, Related
Documentation.
Prepare any other optional
devices or equipment you’ll be
using.
For more information on optional devices and
equipment, refer to the documentation provided with
that equipment.
Install the PMCs on the
MVME240x module.
PMC Module Installation on page 1-12
PMC Slots on page 2-7
For additional information on PMCs, refer to the PMC
manuals provided with these cards.
Install the primary PMCspan
module (if used).
Primary PMCspan Installation on page 1-14
For additional information on PMCspan, refer to the
PMCspan PMC Adapter Carrier Module Installation
and Use manual, listed in Appendix D, Related
Documentation.
Install the secondary PMCspan
module (if used) (Cont’d).
Secondary PMCspan Installation on page 1-17
For additional information on PMCspan, refer to the
PMCspan PMC Adapter Carrier Module Installation
and Use manual, listed in Appendix D, Related
Documentation.