1-6 Computer Group Literature Center Web Site
Hardware Preparation and Installation
1
Unpacking Instructions
Note If the shipping carton is damaged upon receipt, request that the
carrier’s agent be present during the unpacking and inspection of
the equipment.
Unpack the equipment from the shipping carton. Refer to the packing list
and verify that all items are present. Save the packing material for storing
and reshipping of equipment.
!
Caution
Avoid touching areas of integrated circuitry; static discharge can damage
these circuits.
Hardware Configuration
To produce the desired configuration and ensure proper operation of the
MVME2400, you may need to carry out certain hardware modifications
before installing the module.
The MVME2400 provides software control over most options: by setting
bits in control registers after installing the module in a system, you can
modify its configuration. The MVME2400 control registers are described
in Chapter 3, Functional Description, and/or in the MVME2400 Series
VME Processor Module Programmer’s Reference Guide listed under
Appendix D, Related Documentation.
Some options, however, are not software-programmable. Such options are
controlled through manual installation or removal of header jumpers or
interface modules on the base board.
To Next Page
Loading...
