PMC Preparation
http://www.motorola.com/computer/literature 1-11
1
PMC Preparation
For a discussion of any configurable items on the PMCs, refer to the user’s
manual for the particular PMCs.
PMCspan Preparation
You will need to use an additional slot in the VME chassis for each
PMCspan expansion module you plan to use. Before installing a PMCspan
on the MVME240x, you must install the selected PMCs on the PMCspan.
Refer to the PMCspan PMCAdapter Carrier Module Installation and Use
manual for instructions.
System Console Terminal Preparation
Ensure that the switches are set in the proper position for all bits on switch
S3 of the MVME240x board as shown in Figure 1-2. This is necessary
when the PPCBug firmware is used. Connect the terminal via a cable to the
RJ-45 DEBUG connector J2. See Table B-3 on page B-5 for pin signal
assignments. Set up the terminal as follows:
❏ Eight bits per character
❏ One stop bit per character
❏ Parity disabled (no parity)
❏ Baud rate = 9600 baud (default baud rate of the port at power-up);
after power-up, you can reconfigure the baud rate with PPCBug’s
PF command
To Next Page
Loading...
