1-14 Computer Group Literature Center Web Site
Hardware Preparation and Installation
1
Figure 1-3. Typical Single-width PMC Module Placement on MVME240x
6. Insert the two short Phillips screws through the holes at the forward
corners of the PMC module, into the standoffs on the MVME240x.
Tighten the screws.
7. If installing two single-width PMCs, repeat the above procedure for
the second PMC.
Primary PMCspan Installation
To install a PMCspan-002 PCI expansion module on your MVME240x,
refer to Figure 1-4 on page 1-16 and perform the following steps:
Note This procedure assumes that you have read the user’s manual that
was furnished with the PMCspan, and that you have installed the
selected PMCs on the PMCspan according to the instructions
given in the PMCspan and PMC manuals.
To Next Page
Loading...
