Hardware Installation
http://www.motorola.com/computer/literature 1-17
1
5. Place the PMCspan on top of the MVME240x module. Align the
mounting holes in each corner to the standoffs, and align PMCspan
connector P4 with MVME240x connector J6.
6. Gently press the PMCspan and MVME240x together, making sure
that P4 is fully seated in J6.
7. Insert the four short Phillips screws through the holes at the corners
of the PMCspan and into the standoffs on the MVME240x module.
Tighten the screws.
Note The screws have two different head diameters. Use the screws
with the smaller heads on the standoffs next to VMEbus
connectors P1 and P2.
Secondary PMCspan Installation
The PMCspan-010 PCI expansion module mounts on top of a
PMCspan-002 PCI expansion module. To install a PMCspan-010 on your
MVME240x, refer to Figure 1-5 and perform the following steps:
Note This procedure assumes that you have read the user’s manual that
was furnished with the PMCspan, and that you have installed the
selected PMCs on the PMCspan according to the instructions
given in the PMCspan and PMC manuals.
1. Attach an ESD strap to your wrist. Attach the other end of the ESD
strap to the chassis as a ground. The ESD strap must be secured to
your wrist and to ground throughout the procedure.
2. Perform an operating system shutdown. Turn the AC or DC power
off and remove the AC cord or DC power lines from the system.
Remove chassis or system cover(s) as necessary for access to the
VME modules.
To Next Page
Loading...
