Installation 17
In-dash DIN Mount
The In-dash DIN Mount is a rectangular (2” high x 7” wide) mount that can be adapted to
most vehicles produced today that contain a standard ‘Single DIN’ opening.
During installation, the display can be adjusted to provide optimal accessibility using the
foll
owing pivot and mounting adjustments (see Figure 13):
• Swivel: up to 13°
• Tilt: up to 35°
• Vertical: up to 70 mm
• Horizontal: up to 30 mm
• Extension out: up to 48 mm
.
The In-dash DIN Mount has no parts that can be adjusted by the user.
Mount readjustment can only be performed by service technicians.
Figure 13
8.4" Display - In-dash DIN Mount
35
°
Tilt
13
°
Swivel
Swivel Adjustment Screws
Tilt Adjustment
Screws
Vertical
Mounting
Holes
Horizontal
Adjustment Holes
In/Out
48 mm
Left/Right 30
mm
Up/Down
70
mm
Four M4, 10 Screws
To Next Page
Loading...
