52 MW810 Mobile Workstation Vehicle Installation Manual
Step 13. Select the first NAV-EKFSTATUS message from the “Message” drop list and click
the button to save.
Step 14. From the left side window, select UBX > CFG (Config)
> CFG (Configuration).
Step 15. Check "Save current configuration" and "Devices" options and click the
button to save.
Step 16. From the left window pane, select UBX > CFG (Config
) >EKF (EKF Settings).
Step 17. Check the “Clear the Calibration Data” option and click the button to
save (see See “Check the “EKF Enabled”, Clear Calibration Data, Clear Temperature
Table options and click the button to save.” on page 50.).
To Next Page
Loading...
