16
6802982C85-C
• The MW810 Manager application allows selecting the state of the Bluetooth module
after operating system start. Factory registry setting is ON.
Smart Card Reader
The MW810 12.1" Displays incorporate a Smart Card Reader based on the OMNIKEY®
Smart@Link Chipset 83C230K203 with an internal USB 2.0 Host Interface (also compliant
with USB 1.1) with a transmission speed of 12 Mbps (USB 2.0 full speed).
Key Features:
• Complies with ISO 7816
• EMV² 2000 Level 1
• GSA Fips201 approved product list
• PC/SC driver
• Protocols T=0, T=1 (2-wire: SLE 4432/42 (S=10), 3-wire: SLE 4418/28 (S=9))
• Card size ID-1 (full-size)
• Card types 5V, 3V and 1.8V Smart Cards
• Smart Card interface speed 119 Kbps (when supported by card)
• Smart Card clock frequency Up to 8 MHz
• Smart Card detection
• Card vendor supplied Application Program Interface
• Windows XP
• Windows Vista (32bit / 64bit)
Installation
Generally, the drivers and the configuration utility are already preinstalled. If the drivers and
the tools have not yet been installed, you can find the install package in the
D:\Setup\SmartCard folder of the original MW810 operating system image or reinstall the
SCR software by using the MW810 Field Support Kit CD-ROM.
If it should be necessary to reinstall the SCR software, proceed as follows:
• Close all open programs.
• Connect USB CD-ROM drive to the CPU
• Insert the Field Support Kit CD into the CD-ROM drive
• When the main menu appears, push the
SPECIAL DRIVERS button and follow the
instructions on the screen
NOTE: You may require administrator rights to install software. Make sure you have the
necessary rights.
User applications can communicate with the SCR device via card vendor supplied
Application Programming Interface.
To Next Page
Loading...
