MW810 Display Owner’s Manual 31
6802982C85-C
Display Adjustment
Display performance can vary due to the graphics card, host computer, lighting conditions
and other environmental factors. In order to get the best image on a monitor, some
adjustments may be required.
The MW810 display provides three options for image adjustment:
• Proper setting of the timing mode (refresh rate and resolution)
• Embedded On-Screen Display control
• Windows On-Screen Display application
Setting the Timing Mode
Set proper video adapter timing mode to maximize the quality of the screen image. The
timing mode consists of the Resolution and Refresh Rate. Recommended screen resolution
is VESA 1024 by 768 pixels; recommended screen refresh rate is 60 Hz.
Set the screen resolution in Display Properties as follows: click the right mouse button at
desktop and select Properties Æ Settings. Select recommended resolution using the
Screen Resolution slider.
Set the screen refresh rate in Display Properties as follows: click the right mouse button at
desktop and select Properties Æ Settings Æ Advanced Æ Monitor. Select recommended
refresh rate in the Screen Refresh Rate field.
If after setting of the video adapter timing mode the quality of the screen image needs to be
improved, use Embedded or Windows On-Screen Display controls to adjust the screen
image.
Embedded On-Screen Display Control
On-Screen Display (OSD) is a control panel on a display screen that allows you to select
viewing options and/or adjust components of the display, such as brightness, contrast,
horizontal and vertical positioning, etc. This section describes controls available to tune the
image via OSD menus.
The OSD panel includes control tabs for activation of different OSD features. In addition, the
MW810 OSD panel provides information about video input parameters as follows:
• Resolution
• Refresh frequency
• Video Input: Analog or Digital (DVI)
• The version of the LCD controller firmware
• The version of the LCD panel (S – standard brightness; H – high brightness)
How to use the embedded on-screen display:
• Push the rotary knob located on the front display panel to activate the OSD control.
• Long push (for 3 seconds or more) activates the Auto Adjust. That's valid only for
RGB video input.
• Rotate the knob to scroll through menu options.
• When a specific OSD feature is selected, activate that feature by pushing of the
rotary knob.
To Next Page
Loading...
