Chapter 34
Over The Air Programming
NOTE: This is a Software Selling Feature.
Over The Air Programming (OTAP) enables remote radio reconfiguration over TETRA network and
Wi-Fi network.
34.1
Receiving LMR OTAP Update
Prerequisites:Your radio display shows an OTAP prompt with Reboot required. Accept
update? text for a new configuration update.
Procedure:
1 Select Accept to accept or Reject to reject the new configuration update.
NOTE: A timer is set when the prompt is displayed. Request is automatically rejected if
there is no user response to the prompt when the timer runs out.
When the OTAP installation prompt is accepted, your radio updates with the new configuration as
received over OTAP. Visible indication guidance and update status is provided during the update.
When the OTAP installation prompt is rejected, your radio returns to idle mode.
34.2
Managing LMR OTAP
Procedure:
1 From the home screen, press the Menu key.
2 Select LMR OTAP.
3 Select one of the following options:
Option Description
Update Preference Currently only User Confirmation to Update Now is
available.
Last Updated Shows the last installed LMR OTAP information and
status of the installation.
34.3
Receiving Non-Mandatory Wi-Fi OTAP Update
Prerequisites:Your radio display shows an Wi-Fi OTAP prompt with Reboot required. Accept
update? text for a new configuration update.
Procedure:
Install updates by using one of the following options:
MN006360A01-AE
Chapter 34: Over The Air Programming
162
To Next Page
Loading...
