123
CHAPTER 5 Command Line Interface
The Motorola Netopia® Gateway operating software includes a command line interface (CLI) that lets
you access your Motorola Netopia® Gateway over a telnet connection. You can use the command line
interface to enter and update the unit’s configuration settings, monitor its performance, and restart it.
This chapter covers the following topics:
◆ “CONFIG Commands” on page 124
◆ “Overview” on page 125
◆ “Starting and Ending a CLI Session” on page 127
◆ “Using the CLI Help Facility” on page 127
◆ “About SHELL Commands” on page 128
◆ “SHELL Commands” on page 129
◆ “About CONFIG Commands” on page 141
◆ “CONFIG Commands” on page 144
To Next Page
Loading...
