143
ues, those values are presented in brackets, with each value separated by a vertical line. For example,
the following CLI step command indicates that the default value is off and that valid entries are lim-
ited to on and off.
option (off) [on | off]: on
You can accept the default value for a field by pressing the Return key. To use a different value, enter it
and press Return.
You can enter the CONFIG step mode by entering
set
from the top node of the CONFIG hierarchy. You
can enter step mode for a particular service by entering
set
service_name
. In stepping set mode
(press Control-X <Return/Enter> to exit. For example:
Netopia-3000/9437188 (top)>> set system
...
system
name (“Netopia-3000/9437188”): Mycroft
Diagnostic Level (High): medium
Stepping mode ended.
Validating Your Configuration
You can use the validate CONFIG command to make sure that your configuration settings have
been entered correctly. If you use the validate command, the Motorola Netopia® Gateway verifies
that all required settings for all services are present and that settings are consistent.
Netopia-3000/9437188 (top)>> validate
Error: Subnet mask is incorrect
Global Validation did not pass inspection!
You can use the validate command to verify your configuration settings at any time. Your Motorola
Netopia® Gateway automatically validates your configuration any time you save a modified configura-
tion.
To Next Page
Loading...
