Motorola Netopia 3397GP - Factory Reset Switch

Administrator’s Handbook
126
Factory Reset Switch
Lose your password? This section shows how to reset the Motorola Netopia® Router so that you can
access the configuration screens once again.
☛ NOTE: Keep in mind that all of your settings will need to be reconfigured.
If you don't have a password, the only way to access the Motorola Netopia® Router is the following:
1. Referring to the following diagram, find the round Reset Switch opening.
2. Carefully insert the point of a pen or an unwound paperclip into the opening.
❑ If you press the factory default button for less than 1/2 a second, the unit will continue to run as
normal.
❑ If you press the factory default button for 1 second, when you release it, the Gateway will perform a
factory reset, clear all settings and configurations, and reboot. Do not hold the button down too long
(5 – 10 seconds). This will destroy any saved default settings as well.
DSL POWER
4 3 ETHERNET 2 1
RESET
ON
OFF
Power
Off / On
LAN
DSL
4
1
2
3
Factory Reset Switch:
3347-02
2247-series
2240N
2241N
2246N
Factory Reset Switch:
Push to clear all settings
Push to clear all settings
Factory Reset Switch:
Push to clear all settings
Factory Reset Switch:
2
3
Power
Off/On
LAN
DSL
4
1
Factory Reset Switch:
7000-series
Push to clear all settings
Push to clear all settings
Factory Reset Switch:
Push to clear all settings