127
CHAPTER 5 Command Line Interface
The Motorola Netopia® Gateway operating software includes a command line interface (CLI) that lets
you access your Motorola Netopia® Gateway over a telnet connection. You can use the command line
interface to enter and update the unit’s configuration settings, monitor its performance, and restart it.
This chapter covers the following topics:
❑ “CONFIG Commands” on page 128
❑ “Overview” on page 129
❑ “Starting and Ending a CLI Session” on page 131
❑ “Using the CLI Help Facility” on page 131
❑ “About SHELL Commands” on page 132
❑ “SHELL Commands” on page 133
❑ “About CONFIG Commands” on page 145
❑ “CONFIG Commands” on page 148
To Next Page
Loading...
