Motorola PM1500 - Page 69

Scrolling to an ID Number in the Call List
Going Directly to an ID Number in the Call List
Sending Selective Call
Sending a Call Alert Page
Answering a Selective Call
Answering a Call Alert Page
1 Press the CALL (of PAGE for Call Alert softkey.
2 The display shows the last ID transmitted or received.
In the case of Selective Call, the display shows the ID
number.
3 Use the navigation keys to enter the call list, or press
the below LIST.
4 Rotate Mode Knob to scroll to the desired list
member.
5 Proceed to step 1 of "Send a Selective Call" or "Send
a Call Alert Page".
1 Press the CALL (of PAGE for Call Alert softkey.
2 The display shows the last ID transmitted or received.
In the case of Selective Call, the display shows the ID
number.
3 Use the navigation keys to enter the call list.
4 Rotate the Mode Knob to scroll to the desired list
entry.
5 Press the numeric keypad to enter the location
number, The display alternately shows the name and
ID number associated with the entry. If there are 10 or
more list entries, the display shows ID LOC#X_. Use
the numeric keypad again to enter the second digit of
the location number.
6 Proceed to step 1 of "Send a Selective Call" or "Send
a Call Alert Page".
1 Press the PTT button to transmit the displayed ID
number. If the radio you are calling is not in service,
the display shows NO ACK. If the other party does not
answer within 20 seconds, the display shows NO
ANSR.
2 Press the EXIT to exit the Selective Call, or press the
PTT button to speak.
3 Press EXIT to hang up. The radio returns to the home
display.
1 Press the PTT button to transmit the displayed ID
number. If the radio you are paging cannot be reached
you will hear only one beep.
2 Press the PTT button to try again, or press EXIT to
hang up. If the radio you called has received your
page, you will hear five beeps. The radio returns to the
home display.
When a Selective Call is received, the display alternately
shows CALL RCV and the current mode name. Then the F
annunciator will flash. You will hear two alert tones.
1 Press the CALL softkey, or press the preprogrammed
call response button.
2 The display shows the last ID number transmitted or
received. In the case of Selective Call, the display
shows the ID number.
3 Press the PTT button to answer the call. If you hear a
busy tone, the system is busy.
4 Press the D below CALL, or the preprogrammed call
response button to hang up. The radio saves the
Caller’s ID number and returns to the home display.
When a call alert page is received, the display alternately
shows PAGE RCV and the current mode name. The F
annunciator flashes, and there is a four beep tone.
1 Press the PTT button to answer the page. The display
shows the current mode. The alert tone and F are
turned off. The ID is saved as the last ID number
received.
2 Press the PTT button to talk, release to listen.
Everyone who belongs to the talkgroup will hear your
transmission.
OR
If you want to respond to the page with a Selective
Call:
a. Press
D below CALL.
b. The display shows the ID of the paging radio.
3 Proceed to step 1 of "Send a Selective Call" or "Send
a Call Alert Page".