7 Web Page Reference
105
Table 12 – PTP 500 Series Bridge Factory Configuration Values
Example PTP 500 Series Configuration Data
For your convenience these two units have been pre-configured as linked Units.
Units:
ODU serial number ODU serial number
0167100000A0 016710000096
Ethernet MAC address Ethernet MAC address
00:04:56:10:00:96 00:04:56:10:00:A0
Configured as:
Master Slave
Target MAC address Target MAC address
00:04:56:20:00:05 00:04:56:20:00:0D
License Key License Key
9eb8-c807-396c-7c3f-2819-393e-1f48-e46f c49a-e2ac-9ca7-3925-e4e2-a8cc-120d-2f5e
IP Address IP Address
169.254.1.2 169.254.1.1
CAUTION
The factory default configuration is set to Region 26. Region 26 allows the PTP 500
Series bridge a maximum transmit power of 27 dBm. If the local regulatory regime
limits the maximum transmit power (EIRP) to less than 27 dBm you should obtain a
new license key containing the correct region code from your local distributor or direct
from Motorola. Alternatively in the short term, you should reduce the maximum
transmit power by following the procedures in Section 7.7.2 ‘Manually Configuring
The Wi
reless Units’.
To Next Page
Loading...
