8 Web Page Reference
114
Once Section 8.3.4.3 “Wireless Configuration” is complete pressing the “Disarm Installation
Agent” button completes the installation process
15
and the audible installation tone will be
switched off. If the installer wishes to modify the installation configuration then the ‘Back’ link
can be used to access the installation wizard steps described above.
After disarming the wireless link the user is presented with a message as shown in Figure 51.
This message has been obtained when configuring the link with a Region Code where
maximum power is used (Region Code of 1 and power of 27 dBm). The unit shows that the
Transmit Power has been reduced to the lower operating power band.
The screen presents hyperlinks to the main configuration and spectrum management pages.
Figure 51 - Optional Post Disarm Configuration 2
After installation the system administrator may wish to modify the wireless units descriptive
configuration (link name and link location). In addition the system administrator may wish to
change the spectrum management configuration of the wireless unit, or look at the analysis of
the 5.8 GHz spectrum to see if the automatic channel selection is appropriate for the system
administrator’s network. It is also recommended that a backup copy of the wireless units
configuration is taken. Hyperlinks are provided on the post disarm page for ease of use.
15
The installation process is completed when both ends of the link are ‘disarmed’.
To Next Page
Loading...
