Motorola PTP 54500 - Page 14

1 About This User Guide
12
List of Figures
Figure 1 - Typical PTP 500 Series Bridge Deployment........................................................................ 27
Figure 2 – PTP 500 Series Bridge Outdoor Unit (ODU) with PTP-LPU ............................................... 28
Figure 3 - Power Indoor Unit (PIDU Plus) – PTP 300/500/600 Series................................................. 29
Figure 4 – PIDU Plus Recovery Switch Location................................................................................. 29
Figure 5 –PTP 300/500/600 Series Bridge PIDU Plus Power Input..................................................... 31
Figure 6 - External DC Supply Only ..................................................................................................... 31
Figure 7 - External DC Supply and AC Supply..................................................................................... 32
Figure 8 - External DC Supply and Redundant AC Supply.................................................................. 32
Figure 9 - Remote LED and Recovery Switch Wiring .......................................................................... 33
Figure 10 – PTP 500 Series Bridge Layer Diagram ............................................................................. 37
Figure 11 - 5.8 GHz UK RTTT Channel Avoidance – 15 MHz Channel Bandwidth Only .................... 44
Figure 12 - 5.4 GHz Available Spectrum Settings - 15 MHz Channel Bandwidth................................ 45
Figure 13 - 5.8 GHz Available Spectrum Settings – 15 MHz Channel Bandwidth............................... 46
Figure 14 - Mounting to pole diameters 25mm (1”) to 50mm (2”) ........................................................ 58
Figure 15 - Integral Safety Loop ........................................................................................................... 59
Figure 16 - Correct Cable Preparation for the Recommended Cable .................................................. 60
Figure 17 - Completed ODU Connector ............................................................................................... 61
Figure 18 - Warning Not To Over tighten Cable Gland ........................................................................ 61
Figure 19 – PTP 500 Series Bridge PIDU Plus Connexion.................................................................. 62
Figure 20 - Connecting the PIDU+ to the ODU .................................................................................... 63
Figure 21 - Disconnecting the ODU...................................................................................................... 64
Figure 22 - Making the Network Connection at the PIDU Plus ............................................................ 66
Figure 23 – PTP 500 Series PIDU Plus Drip Loop Configuration ........................................................ 67
Figure 24 - Using DVM For Alignment.................................................................................................. 71
Figure 25 - Menu Navigation Bar.......................................................................................................... 74
Figure 26 - System Summary Page ..................................................................................................... 75