PROGRAMMING
FEATURES
English
57
• Both radios are turned OFF.
• Both radios are of the same radio model.
2. Unplug any cables (power supply or USB
cables) from the SUCs.
3. Plug one side of the cloning cable mini
connector to one SUC. Plug the other end to
the second SUC.
Note: During the cloning process no power is
being applied to the SUC. The batteries will
not be charged. A data communication is
being established between the two radios.
4. Turn ON the “Target Radio” and place it into
one of the SUCs.
5. On the “Source Radio”, power the radio
following the sequence below:
• Long press the Push-to-Talk (PTT) and Side
Button 2 (SB2) simultaneously while turning
the radio ON.
• Wait for 3 seconds before releasing the
buttons until a distinctive audible tone is
heard.
6. Place the “Source Radio” in its SUC, press and
release Side Button 1 (SB1).
7. After cloning is completed, the “Source Radio”
will sound either a “pass” tone (cloning was
successful) or a “fail” tone (cloning process has
failed). The pass tone sounds like a good key
“chirp” whereas the “fail” tone sounds similar to
a “bonk” tone. If the “Source Radio” is a radio
with a display, it will either show “Pass” or “Fail”
on the display. (A tone will be heard in no more
than 5 seconds).
8. Once you have completed the cloning process,
you should turn the radios “OFF” and “ON” to
bring them to normal user mode (exit “clone”
mode).
What to do if cloning fails
The radio will emit an audible “bonk” indicating
that the cloning process has failed. In the event
that cloning fails, try performing each of the
following before trying to start the cloning
process again.
BRUS_display.book Page 57 Monday, January 16, 2012 5:28 PM
For Sales Information Please Contact RoadTrucker Inc (www.RoadTrucker.com)
8312 Sidbury Rd.; Wilmington, NC 28411 - (800) 507-0482 / (910) 686-4281
To Next Page
Loading...
Need help?
General
