PROGRAMMING
FEATURES
English
59
Bandwidth will be available. If the repeater
feature is mapped (using CPS) to one of the
radio buttons, then the repeater icon will blink.
This indicates that you can use the repeater
‘button’ to toggle ON/OFF repeater. If repeater
is not enabled in the radio this icon will not be
displayed.
Once you have selected the channel you want
to set up for repeater operation, you can move
between the Programming options by short
pressing the PTT or MENU button to program
the frequency, code and bandwidth for the
repeater channel.
To program the Frequency TX, scroll through
the radio options until your display shows:
To program the desired frequency, scroll using
the / buttons until you get the desired
frequency code value. Long press the PTT
button to exit and save or short press the PTT
button to go to the next programming feature
without saving.
Note: If your radio displays the (Power
Select) icon refer to note in ‘Programming
RX (Reception) Bandwidth’ section for
further explanation.
T
X
BRUS_display.book Page 59 Monday, January 16, 2012 5:28 PM
For Sales Information Please Contact RoadTrucker Inc (www.RoadTrucker.com)
8312 Sidbury Rd.; Wilmington, NC 28411 - (800) 507-0482 / (910) 686-4281
To Next Page
Loading...
Need help?
General
