Quick Reference Guide 11
Status Indications
The Imager has two Scan LEDs that provide identical indications. The Imager is
also equipped with a beeper that generates sound indications in variable tones.
NOTE In the corded configuration, beep indications are emitted only from the
connected terminal.
No. LED Beep Indication Description
1. None High/low Bluetooth communication is
disconnected.
2. Short green
flashes
None Attempting to connect over
Bluetooth.
3. None Low/high Imager is connected over
Bluetooth.
4. None High/low Bluetooth communication is
disconnected - Imager is out of
range.
5. None high/low/high/low Properly decoded scan of
Bluetooth pairing bar code.
6. None Long low/
long high/
Bluetooth connection attempt
failed.
7. None Long low/
long high/
Long low/
long high/
Bluetooth connection attempt is
rejected.
8. One green
flash
High Proper scanning indication.
9. None 4 long beeps No Bluetooth communication after
reconnection failure.
10 Red flash 2 short beeps Low battery.
11 Long red
flash
followed by
a green
flash
High/low
High/low
Clean boot was performed
successfully.
To Next Page
Loading...
