16 RS507 Hands-Free Imager
NOTE When using the application on your mobile computer in “Pick List” mode,
the Bright Center Dot can be positioned anywhere on the symbol.
The aiming pattern is smaller when the Imager is closer to the symbol and
larger when it is farther from the symbol. Scan symbols with smaller bars
or elements (mil size) closer to the Imager and those with larger bars or
elements (mil size) farther from the Imager.
2. Hold the Imager between two and eleven inches from the bar code (depending
on the bar code density).
NOTE When a symbol is under transparent plastic or on a mobile computer
screen, it is recommended to use a tilt (pitch) or skew scan angle to avoid
reflection.
3. Press the Scan Button. The aiming pattern illuminates red indicating that the
laser is on. One green flash of the Scan LED and a high beep indicates that a
bar code was properly decoded.
Customize the Imager
Changing from Trigger to Triggerless Configuration
To Change from Trigger to Triggerless configuration:
1. Remove the Comfort Pad (See Comfort Pad Replacement on page 21).
2. Remove the Trigger Swivel Assembly (See Trigger Swivel Assembly
Replacement on page 21).
3. Install the Triggerless Strap Holder (See Triggerless Strap Holder Replacement
on page 22).
4. Install the Comfort Pad (See Comfort Pad Replacement on page 21).
5. Perform a cold boot (See Cold Boot on page 18).
Changing Triggerless to Trigger Configuration
To change from Triggerless to Trigger configuration:
1. Remove the Comfort Pad (See Comfort Pad Replacement on page 21).
2. Remove the Triggerless Strap Holder (See Finger Strap Replacement
(Triggerless Strap Holder) on page 24).
To Next Page
Loading...
