Motorola RS507 - Changing the Imager Behavior

Quick Reference Guide 17
3. Install the Trigger Swivel Assembly (See Trigger Swivel Assembly
Replacement on page 21).
4. Install the Comfort Pad (See Comfort Pad Replacement on page 21).
5. Perform a cold boot (See Cold Boot on page 18).
6. Press and release the Scan Trigger to enable the manual triggering mode (this
operation disables the default Triggerless mode).
NOTE When the Imager is used with the WT4090, Triggerless mode can also be
disabled from the WT4090.
Changing the Imager Behavior
The Imager operation can be configured by scanning custom bar code tables. The
following table provides examples of configurable Imager features. For more
information, refer to the RS507 Hands-Free Imager Product Reference Guide, p/n
72E-120802-01.
Feature Description Default Setting
Beep on
reconnection
attempt.
When this parameter is enabled, the
Imager emits a low/high beep when
Bluetooth link is reconnected.
Disabled.
Motion
sensing.
When this parameter is enabled, the
Imager automatically scans when motion
stops in front of the Imager and a bar code
is placed within the depth of field of the
Imager.
Enabled for
triggerless model.
Disabled for
triggered model.
Proximity
sensing.
When this parameter is enabled, the
Imager automatically scans when sensing
proximity to an object and a bar code is
placed within the depth of field of the
Imager.
Enabled for
triggerless model.
Disabled for
triggered model.
Proximity
distance.
When using proximity sensing, you can set
proximity distance to Short, Mid or Long.
Long.
Low battery
indication.
When this parameter is enabled, the
Imager flashes red every 15 seconds when
battery power is low.
Disabled.