Motorola RS507 - Comfort Pad Replacement; Installation; Trigger Swivel Assembly Replacement

Quick Reference Guide 21
Comfort Pad Replacement
Removal
1. Flip the Imager over, such that the bottom of the
Imager and the Comfort Pad are facing upwards.
2. Insert the tip of your finger under the edge of the
Comfort Pad at the back of the Imager.
3. Lift the Comfort Pad upwards and remove it from the
Imager.
Installation
1. Position the Comfort Pad onto the Imager as shown.
2. Press the Comfort Pad onto the Imager. When properly installed, the Comfort
Pad locks into place.
Trigger Swivel Assembly Replacement
Removal
1. Turn the Imager upside-down.
2. Remove the Comfort Pad.
3. Use a paper clip or similar object to
press the Release Latch.
4. Rotate the Trigger Swivel Assembly
(or Triggerless Strap Holder) to
align with the back of the Imager.
5. Lift the Trigger Swivel Assembly off
the Imager.
CAUTION Removing the Comfort Pad other than the described above may
result in damage to the Trigger Swivel Assembly of the Imager.
1
2
3
Release Latch
Imager Back
Triggerless
Strap Holder