22 RS507 Hands-Free Imager
Installation
1. Turn the Imager upside-down.
2. Position the Trigger Swivel Assembly to align with
the back of the Imager.
3. Lower the Trigger Swivel Assembly to the Imager.
4. Rotate Trigger Swivel Assembly 1/4 turn
counterclockwise.
5. Press the Comfort Pad onto the Imager. When
properly installed, the Comfort Pad “locks” into
place.
Note: An optional Triggerless Strap Holder should be installed when the
Imager is intended to be used in Motion and Proximity Initiated Bar code Read
mode.
Triggerless Strap Holder Replacement
Removal
1. Turn the Imager upside-down.
2. Remove the Comfort Pad.
3. Use a paper clip or similar object
to press the Release Latch.
4. Rotate the Triggerless Strap
Holder to align with the back of
the Imager.
5. Lift the Triggerless Strap Holder
off the Imager.
1
2
3
Release Latch
Imager Back
Triggerless
Strap Holder
To Next Page
Loading...
