Quick Reference Guide 23
Installation
1. Turn the Imager upside-down.
2. Position the Triggerless Strap
Holder to align with the back of
the Imager.
3. Lower the Triggerless Strap
Holder to the Imager.
4. Rotate Triggerless Strap Holder
1/4 turn counterclockwise.
Finger Strap
Replacement (Trigger
Swivel Assembly)
Removal
1. Remove the Finger Strap from the
Strap Buckle.
2. Pull the Finger Strap out of the
Trigger Swivel Assembly.
Installation
1. Align a new Finger Strap with the
Slots in the Trigger Swivel Assembly.
2. Gently press the Strap Pins to
engage with the slots of the Trigger
Swivel Assembly. The Strap Pins
snap into the slots.
3. Slip the Finger Strap through the
Strap Buckle.
Strap Pins
Slots Strap Buckle
Finger Strap
Trigger Swivel
Assembly
To Next Page
Loading...
