178 Customizing the Menu System
Personalizing the Quick Access Menu
You can replace the default Quick Access menu
features described on page 65 with any of the
following features.
To change a default quick access feature to one of
the features listed above:
1. Press
E
and then press
M
to scroll to the
feature you wish to change.
2. Press and hold
O
to access the list of
features available.
3. Press
M
to scroll through the list until you
find the desired feature.
4. Press
O
to store the displayed feature in the
new location. You will see
Completed
.
Icon Quick Access Feature
D
Find by Location recalls a Phone Book entry
by its memory location number.
F
Add Entry to Phone stores entered numbers
in the next available phone memory location.
T
Add Entry to SIM stores entered numbers in
the next available SIM card location.
N
Ring Volume displays and sets the incoming
call ring tone volume.
e
Check Signal checks the strength of the
signal from the satellite network.
V
Switch Memory switches one-touch dialing
between the phone and SIM memories
depending on the current setting.
Y
Last Call Timer displays the duration of your
last call.
%
Show Services displays a list of service
phone numbers programmed by your service
provider.
$
Mode Selection: This feature is not currently
supported.
To Next Page
Loading...
