6809495A77-O September 23, 2005 17
Level 1 and 2 Service Manual Tools and Test Equipment
Tools and Test Equipment
This section describes how to disassemble a Motorola SLVR L7 telephone. Table 1
lists the tools and test equipment used. Use either the listed items or equivalents.
Table 1. General Test Equipment and Tools
Motorola
Part Number
1
Description Application
See Table 6. Charger Used to charge battery and power phone.
0180386A82
Antistatic Mat Kit (includes 66-80387A95 antistatic
mat, 66-80334B36 ground cord, and 42-80385A59
wrist band)
Provides protection from damage to phone caused
by electrostatic discharge (ESD).
6680388B67 Disassembly Tool, plastic with flat and pointed
ends (manual opening tool)
Used during assembly/disassembly.
6680388B01 Tweezers, plastic Used during assembly/disassembly.
RSX4043-A Torque Driver Used to remove and replace screws.
—
Torque Driver Bits T3, and T6 Plus, Apex 440-5IP
Torx Plus or equivalent
Used with torque driver.
HP34401A
2
Digital Multimeter Used to measure battery voltage.
W.FL-LP-IN Coaxial cable connector removal tool
Used to attach or remove coaxial cable connector
to/from circuit board.
1. To order in North America, contact Motorola Aftermarket and Accessories Division (AAD) by phone at (800) 422-4210 or
FAX (800) 622-6210; Internationally, you can reach AAD by phone at (847) 538-8023 FAX (847) 576-3023.
2. Not available from Motorola. To order, contact Hewlett Packard at (800) 452-4844.
1 and 2
6809495A77-O
Motorola SLVR L7
To Next Page
Loading...
