Motorola SLVR L7 - Removing and Replacing the Transceiver PC Board Shield

22 September 23, 2005 6809495A77-O
Disassembly Motorola SLVR L7
Removing and Replacing the Transceiver PC Board Shield
1. Remove the battery cover, battery, SIM, and antenna, as described in the
procedures.
2. Using a Torx Plus driver with a T6 bit, remove the 6 housing screws from the
phone. Set the screws aside for re-use (see Figure 8).
3. Lift the PCB shield away from the phone..
050973o
Figure 8. Removing and Replacing the Transceiver PC Board Shield.
050974o
Figure 9. Removing and Replacing the Transceiver PC Board Shield.
Housing Screws
Housing Screws
Transceiver PC Board Shield