Introduction Installation Troubleshooting Glossary License
SBV5120 VoIP Cable Modem User Guide 15
Setting Up a USB Driver in Windows 2000
1 Insert the SURFboard VoIP Cable Modem CD-ROM in the CD-ROM drive. This CD contains the USB drivers
and must be inserted and read by the PC before you connect the VoIP cable modem to the PC.
2 Connect the VoIP cable modem to your computer with a USB cable. For further instructions, see “Cabling and
Startup for a Single User” on page 8. A few seconds after you complete the USB connection, the Found New
Hardware Wizard window is displayed:
3 Click Next. The following window is displayed:
Be sure “Search for a suitable driver for my device” is selected.
Although your VoIP cable modem model number may be different than in the images in this guide,
the procedure is the same.
To Next Page
Loading...
