Introduction Installation Troubleshooting Glossary License
SBV5120 VoIP Cable Modem User Guide 18
Setting Up a USB Driver in Windows Me
1 Insert the SURFboard VoIP Cable Modem CD-ROM in the CD-ROM drive. This CD contains the USB drivers
and must be inserted and read by the PC before you connect the VoIP cable modem to the PC.
2 Connect the VoIP cable modem to your computer with a USB cable. For further instructions, see “Cabling and
Startup for a Single User” on page 8. A few seconds after you complete the USB connection, the Add New
Hardware Wizard window is displayed:
3 Click Next. Windows automatically searches for the correct USB drivers and installs them. If the installation is
successful, the following window is displayed. Otherwise, be sure the SURFboard VoIP Cable Modem
CD-ROM is correctly inserted in your CD-ROM drive.
4 Click Finish to complete the installation.
When you finish setting up the USB driver, you can continue with “Configuring TCP/IP in Windows 98 Second
Edition, or Windows Me” on page 20.
Although your SURFboard VoIP cable modem model number may be different than in the images in
this guide, the procedure is the same.
To Next Page
Loading...
