Introduction Installation Troubleshooting Glossary License
SBV5120 VoIP Cable Modem User Guide 19
Setting Up a USB Driver in Windows XP
1 Insert the SURFboard VoIP Cable Modem CD-ROM in the CD-ROM drive. This CD contains the USB drivers
and must be inserted and read by the PC before you connect the VoIP cable modem to the PC.
2 Connect the VoIP cable modem to your computer with a USB cable. For further instructions, see “Cabling and
Startup for a Single User” on page 8. A few seconds after you complete the USB connection, the Found New
Hardware Wizard window is displayed:
3 Be sure “Install the software automatically” is selected.
4 Click Next. Windows automatically searches for the correct USB drivers and installs them. the installation is
successful, the following window is displayed:
5 Click Finish to complete the installation. Otherwise, be sure the SURFboard VoIP Cable Modem CD-ROM is
correctly inserted in your CD-ROM drive.
When you finish setting up the USB driver, you can continue with “Configuring TCP/IP in Windows XP” on
page 26.
Although your VoIP cable modem model number may be different than in the images in this guide,
the procedure is the same.
To Next Page
Loading...
