10 - 2 Symbol DS3578 Digital Scanner Product Reference Guide
Errors While Scanning
Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.
Symbology Parameter Defaults
Table 10-1 lists the defaults for all symbologies parameters. There are two ways to change the default values:
•
Scan the appropriate bar codes in this guide. These new values replace the standard default values in
memory. To recall the default parameter values, scan the Default Parameters on page 5-4.
•
Download data through the device’s serial port using SSI. Hexadecimal parameter numbers are shown in this
chapter below the parameter title, and options are shown in parenthesis beneath the accompanying bar
codes. See the Simple Serial Interface (SSI) Programmer’s Guide for detailed instructions for changing
parameters using this method.
NOTE See Appendix A, Standard Default Parameters for all user preferences, hosts, and miscellaneous default
parameters.
Table 10-1
Parameter Defaults
Parameter Default
Page
Number
UPC/EAN
UPC-A Enable 10-7
UPC-E Enable 10-7
UPC-E1 Disable 10-8
EAN-8/JAN 8 Enable 10-8
EAN-13/JAN 13 Enable 10-9
Bookland EAN Disable 10-9
Decode UPC/EAN/JAN Supplementals (2 and 5 digits) Ignore 10-10
User-Programmable Supplementals 10-13
UPC/EAN/JAN Supplemental Redundancy 10 10-14
UPC/EAN/JAN Supplemental AIM ID Format Combined 10-14
Transmit UPC-A Check Digit Enable 10-15
Transmit UPC-E Check Digit Enable 10-15
Transmit UPC-E1 Check Digit Enable 10-16
UPC-A Preamble System Character 10-16
UPC-E Preamble System Character 10-16
UPC-E1 Preamble System Character 10-18
To Next Page
Loading...
